Oxyfuel Cutting

Our enterprise has gained immense recognition by offering Oxyfuel Cutting that is demanded for cutting of various types of conductive metal sheets and components. Offered service is rendered in close-coordination with clients to understand their requirements to provide them fabrication of medium thickness sheets in various shapes. Furthermore, we assure that this cutting job ensures clean and smooth surface with near vertical drag lines. The offered Oxyfuel Cutting are reckoned by among our clients for its flexibility, reliability and cost-effectiveness.

In Oxyfuel cutting fuel gases and oxygen are used to cut sheet steel. Oxy-fuel cutting is a chemical reaction between pure oxygen and steel to form iron oxide. Preheat flames are used to raise the surface or edge of the steel to approximately 1800°F (bright red color). Pure oxygen is then directed toward the heated area in a fine, high pressure stream. As the steel is oxidized and blown away to form a cavity, the preheat and oxygen stream are moved at constant speed to form a continuous cut. Only metals whose oxides have a lower melting point than the base metal itself can be cut with this process. Hence, Only low carbon steel and some low alloys meet the above condition and can be cut effectively with the oxy-fuel process. IT can be best used for thickness of around 40 mm.

Oxyfuel cutting provides best results in square top corner (with minimum radius). It can cut face flat top to bottom (no undercut). It can cut face square with respect to top surface. Provides clean smooth surface with near vertical drag lines and little to no slag on bottom edge (easily removed by scraping)

We have oxyfuel Cutting machines with bed size of 2.8 x 6 mtrs & 6.5 x 16 mtrs. These machines are used in medium thickness sheet steel fabrications.

Plasma advantages vs. laser